Chris Coffee Service Alexia User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
Alexia'Espresso'Machine'
4'
First Time Set Up, Continued
Before plugging the machine in, verify the steam knob is closed and the brew lever
is in the down position. Also*make*sure*the*power*switch*is*in*the*center*off*“O”*
position and the drip tray is in place.
Plug the machine into the outlet* and then turn the
power*switch*to*the*fill*“I** position.
Raise the brew lever for at least 30 seconds until
water comes out of the group head and then lower
the brew lever.
After filling the boiler insert the portafilter into the
group head so it heats up with the machine.
Turn*the*power*switch*to*the*on*“II”*position*which*will*activate*the*heater.
The heating indicator light will illuminate and the machine will start heating up. You
will hear some gurgling noises as it heats up which is normal.
The machine should reach temperature in approximately 15 minutes, but to make
delicious espresso with thick rich crema it is necessary to allow the machine to be
heated for 30-45 minutes with the portafilter kept in the grouphead.
* The electrical outlet must be a 3 prong 120V grounded outlet. No adaptors or extension cords
should be used. A timer may be used to turn the machine on and off, but it must be a 3 prong
grounded timer rated for 15 amps. A GFCI outlet is recommended but is not necessary.
** The fill position on the power switch only needs to be used on the first time setup or if the boiler has
been emptied. The fill switch position allows the boiler to fill without the heater being activated to
protect it during the fill process. Once the boiler has been filled the machine can be turned on
normally*to*the*on*“II”*position.
Before Each Use
Verify the steam knob is closed and your brew lever is pointing straight down.
Fill the reservoir with cold softened water.
Place whichever portafilter you intend to use into the group head and then turn the
power switch to*the*on*“II”*position.
Let the machine warm up for 30-45 minutes for optimal performance.
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 21 22

Comments to this Manuals

No comments